Yaesu FT-840 HF Transceiver in EXCELLENT shape and working Very Well

Description

Yaesu FT-840 HF Transceiver in EXCELLENT shape with the manual on CD,  Yaesu hand microphone, and the DC power cord.  This is a great STOCK radio.
Has all band transmit enabled.
The 2 watt  8.2 ohm regulator resistor that typically burns up has been replaced with an upgraded beefy 7 watt  8.2ohm resistor that will handle the heat and last a long time.
I get Excellent reports and receive is very sensitive. Radio is right on frequency all around.
Compact in size yet loaded with great features, 100 watt output (25 on AM), and a nice receiver.
Has 100 memories. The FT-840 uses a modular die-cast RF power amplifier/heat sink with an internal thermally switched fan to allow full transmitter output without any rear panel protrusions to block access to connectors and controls. Modular circuit design employs surface-mount components on composite epoxy boards for high efficiency, reliability and serviceability. The FT-840 weighs under 5 kg, and runs cool all the time.
16 Bit Main CPU. The 16-bit main microprocessor is assisted by four co-processors to provide the simplest possible control interface for the operator. Two independent (A/B) VFOs for each band (20 total) hold their own frequencies and modes, as well as clarifier offsets and repeater shifts, when used. One hundred memories store all of this data for both VFOs, giving a total of 220 independent sets of frequency, mode and other selections. Of course all memories can be freely tuned and scanned, but ten special memories also let you limit the tuning/scanning range between their stored frequencies. External PC control of most functions by a serial-port-equipped external personal computer is made possible using the FIF-232C CAT Interface option connected to the CAT jack on the rear panel.
Wide receiver dynamic range: The receiver tunes all frequencies between 100 kHz and 30 MHz in 10-Hz steps. For clear weak-signal work, the low-noise, high-performance receiver front-end feeds an active FET balanced mixer. A 12-dB attenuator can be inserted in the receiver front end for clear copy of even very strong signals.
CLEAN TRANSMITTER OUTPUT:
The digitally synthesized local signals ensure clean, low-noise transmitter output: up to 100 watts on all HF amateur radio bands in CW, SSB and FM* modes, and up to 25 watts carrier in AM mode. *FM operation requires optional unit.
DIRECT DIGITAL FREQUENCY SYNTHESIS:
Two direct digital synthesizers (DDS) and a magnetic rotary encoder provide silent, silky-smooth tuning, pure local signals and very fast transmit/receive switching. Frequency accuracy and stability are assured by driving both DDSs from a single master oscillator.
IF SHIFT, REVERSE CW SIDEBAND & EXTRAS:
Interference rejection is facilitated by the unique "up-down-up' conversion scheme, and also provides an adjustable IF shift control to vary the receiver pass-band. Special features for CW include the reverse CW sideband feature, which prevents having to re-tune lost signals when switching between LSB and CW modes, and helps side-step adjacent interference. The adjustable CW pitch (400-Hz 1000-Hz) lets you match that used by your TNC or multi-mode controller.
Buyer pays shipping for a well packed and insured shipment.
Buy from me with confidence as I have excellent feedback.
.
PLEASE NOTE: EBAY HAS NOW STARTED TO ADD SALES TAX ON INVOICES DEPENDING ON WHAT STATE YOU ARE IN, YOU WILL SEE IF THERE IS ANY SALES TAX YOU WILL BE CHARGED ON THE INVOICE BEFORE YOU PAY IT SO PLEASE CHECK. THIS HAS NOTHING TO DO WITH ANY SELLER (Evey seller now has this added if it applies to a state that Ebay charges sales tax on). AGAIN, NO SELLER HAS ANY CONTROL OVER THIS AND EBAY COLLECTS THE SALES TAX FROM THE PAYPAL PAYMENT BEFORE THE PAYMENT ACTUALLY REACHES A SELLER SO WE NEVER SEE IT.