EICO Model 753 Tri-Band Transceiver

Description

EICO Model 753 Tri-Band Transceiver, I do not have the power supply for this radio and csn not test it, but it looks in good condition with all components and tubes intact, please check out all photos. Two of the knobs are missing but I may have two similar knobs that I will install.Will ship Fedex or UPS.
The EICO Model 753 SSB/AM/CW Transceiver incorporates a filter type single sideband trans- mitter and a single conversion superheterodyne receiver for operation on the 80, 40 and 20 meter amateur bands. It is equally suited for mobile and fixed station use.
In fixed station use, the Model 751 AC Supply/Speaker Console (117 VAC, 60 cps) is required for its operation. In mobile use, the Model 752 DC Supply (12 VDC , positive or negative ground) is required. Both supplies have been designed integrally with the 753 and provide the requisite filtering and regulation. They can not be supplanted by supplies of other manufacture if the design capabilities of the 753 are to be obtained.
FEATURES SPECIFICATIONS
o Full band coverage on 80, 40 and 20 meters. o Receiver off set tuning (up to ±lOkc) without altering transmitter frequency. o Built-in VOX. o Panel selected VOX, PTT & STANDBY. o High level dynamic ALC to prevent flat-topping or splatter and permit the use of a linear amplifier. o Auto- matic carrier level adjustment on CW and AM. o Dual ratio ball drive per mits single knob 6:1 rapid tuning and 30:1fine tuning (over 10 degrees of scale). o Position of hairline adjustable on panel. o Illuminated S-meter/PA Cathode Current Meter and tuning dial. o Fast attack, slow decay AGC. o Grid-block break-in CW keying. o Product detector for SSB and CW, triode detector for AM. o TR relay with auxiliary contacts for use with high power linear amplifier. o Includes mobile mounting bracket.
ADDITIONAL SPECIFICATIONS
FREQUENCY CO VE RAGE: 3490-4010kc, 6990-7310kc, 13890-14410kc. SSB EMISSIONS: LSB 80 and 40 meters, USB 20 meters. RF POWE R INPUT: 200 watts SSB PE P and CW, lOO watts AM. RF POWE R OUTPUT: 120 watts SSB PE P and CW, 30 watts AM. OUTPUT PI NETWORK MATCHING RANGE: 40-80 ohms. SSB GENE RATION: 5. 2 Mc crystal lattice filter; bandwidth 2. 7kc at 6db. STABILITY: 400 cps af ter warm-up. SUPPRESSION: Carrier-50db; unwanted sideband-40 db. RECEIVER: Sensitivity luv for lOdb S/N ratio: selectivity 2. 7kc at 6db; audio output over 2 watts (3. 2 ohms). PANEL CONTROLS & CONNECTORS: Tuning, Band Selector , AF Gain, RF Gain, MIC Gain with calibrator switch at extreme CCW rotation, Hairline Set (capped), Mode (SSB, AM, CW, Tune), Function (Off , Standby, PTT, VOX), Carrier Balance, Exciter Tune, PA Tune, PA Load, Receiver Offset Tune, MIC input, phone jack. REAR CONTROLS & CONNECTORS: VOX Threshold, VOX delay, VOX sensitivity, Anti-VOX sensitivity, PA Bias adjust, S-Meter zero adjust, power socket, external relay, antenna connector , key jack, accessory calibrator socket. ME TERING: PA cathode on transmit, S-Meter on receive. SIZE (HWD): 5-13/16" x 14-1/4" x 11-1/4". POWE R REQUIREMENTS: 750 VDC