AnyTone Smart 10 Meter Radio for Truck, Small Size,AM PEP Power Over 16W

Description

SPECIFICATION
GENERAL
Modulation Mode AM/FM
Frequency Range 28.000-29.695MHz
Frequency Tolerance ±5.0ppm
Input Voltage 13.2V
Dimensions 109x104x25mm
Weight 421g
Ferquency Control PLL Synthesizer
Operating Temperature Range -20℃ ~ +50℃
Current Drain
Transmit 2A MAX
Receive Squelched 0.3A
VOL Max 0.8A
Antenna Connector UHF,SO-239
TRANSMITTER
Power Output 8 Watts FM/AM
Transmission interference inferior to 4nW(-54dBm)
Frequency Response 300-3000Hz
Modulated signal distortion inferior to 5%
Output Impedance 50 ohms
RECEIVER
Sensitivity Less than 1uV for 10dB(S+N)/N
Image Rejection 70dB
Adjacent Channel Rejection 60dB
IF Frequencies
1st 10.695MHz
2nd 455KHz
Automatic Gain Control(AGC) Less than 10dB change in audio
Output for inputs from 10 to 50000uV
Squelch less than 1uV
Audio Output Power 1Watts
Frequency Response 300-3000Hz
WARNING
Your equipment is protected against an inversion of polarities. However, before switching it on, you are advised to check all the connections. Your equipment must be supplied with a continued current of 12 volts (A)
Lorries generally have two batteries and an electrical installation of 24 volts, in which case it will be necessary to insert a 24/12 volt converter into the electrical circuit. The following connection steps should be carried out with the power cable disconnected from the set. a.)Check that the battery is of 12 volts. b.) Locate the positive and negative terminals of the battery (+ is red and – is black). Should it be necessary to lengthen the power cable, you should use the same or a superior type of cable.